WL-GI-1550

User Name guest
Password guest
IP Address 192.168.1.1
DHCP Enabled
Wireless Yes
USB N/A
Ports LAN (1x)
MAC Address 08-10-74-13-45-FA
Serial / Part No. NC-0007000019
Power Supply – input 230V ~ 50Hz 95Ma
output 9V 500mA
L.E.D/ Display PWR (1x), CPU (1x), LINK (1x), 100M (1x), RX (1x), TX (1x)
Device Shell Silver Shell
Firmware Upgrade No

Installation

Connect a Ethernet Cable from the LAN port of the Dynamode router to your PC’s Network Card
Please Make sure that your PC is enabled to obtain IP Address Automatically:

Control Panel > Internet Connection > Right Click on Wireless Local Area Network >
Properties > TCP/IP > Properties > check obtain IP Address Automatically
Please make sure that ALL Firewall or any other Viruses Protections are Turned OFF or Disabled.
Please check that the Your PC/Laptop received an IP Address from the router:
Click on START > RUN > Type in CMD > OK
in the command prompt window please type IPCONFIG
your IP Address should be 192.168.1.X
Default Gateway should be 192.168.1.1
If you received the result above means that you are connected to the router if not please repeat the steps above.
Once you have the received the IP Address above, minimize the Command prompt window and open your Internet Browser
(firefox, Internet Explorer)
Type in the Address Bar http://192.168.1.1 > Username: guest > Password: guest
this should open the Routers Interface.
if you can see this screen, then the device is installed correctly.

 

Hard Reset

Take a PIN and hold down the “Reset” button on the back of the router,
HOLD IT until the CPU light goes out, then comes back on (Approx. 10 – 15 seconds), then release.
All the L.E.D’s should go OFF, then come back ON.
When the WAN light is ON and SOLID, then the Router is Ready for use

 

Change LAN Address

Open your Internet Browser (firefox, Internet Explorer)
Type in the Address Bar http://192.168.1.1 > Username: guest > Password: guest
this should open the Routers Interface.
Click on IP CONFIG ( left-hand side)
Select the option STATIC IP USER
Enter a new IP address into the IP ADDRESS field
Enter a new Subnet Mask into the SUBNET MASK field
Enter a new Gateway address into the GATEWAY field
Click on the SAVE button (top-right)
Click on the APPLY button at the bottom.

Wireless Setup

Open Internet Explorer, and type into the address bar http://192.168.1.1
Username: Guest and Password: Guest
Click on RADIO (left)
This will show the BASIC SETTINGS screen
Down this screen, you will see the option SSID set to DEFAULT
Change the name
Click on the SAVE button (top right of screen)
Click on APPLY (bottom of screen)
Click on SECURITY (left)
Choose Authentication type WEP
Choose Key Length 64
Choose WEP Mode HEX
Enter HEX Key:
HEX:
Characters – Letters A-F and/or Numbers 0-9
64 Bit – 5 Pairs
Example shown:  e40f9ad2c1
Click on the SAVE button (top right of screen)
Click on APPLY (under key 4)

Now go to WIRLESS NETWORKS (bottom-right of screen, next to clock)
Right-click on WIRLESS NETWORKS, and click on VEIW AVALABLE WIRELESS NETWORKS
This will open a Wireless Utility.
You will see your Reuters SSID In the list
Double-click on your SSID name to connect.
You will be prompted to enter a Security Key
Enter the WEP key you created on the Router.